How To Change Batteries In Swiffer Wet Jet

Is there a problem with the wet Jet on your Swiffer? The batteries in it probably need to be replaced. To replace the batteries in your Swiffer Wet Jet, you will need to know-how. Fortunately, there are actions you can take to accomplish this goal.




Also See: How to fix e3 error on electric fireplace

Table of Contents

Wet Jet Batteries by Swiffer

4 AA batteries are required to power your Swiffer wet jet. In addition, if you wish to get alkaline batteries, do so.

  1. The first step is to get rid of the cleanser. The Swiffer cleaner must be removed before you can access the battery compartment. Wet Jet must be held upside down and beneath Swiffer pole and cleaning button to do this task. The bottle of cleanser should come out as soon as you pull it down.
  2. The battery tab should be removed at this point. You’ll notice a finger notch with the battery tab in the battery compartment. Just enter your finger into the opening and pull it down to remove the battery cover. ‎
  3. After that, it’s time to swap out the batteries. Remove the old batteries from the battery compartment and install the new ones to finish this step. Make sure you’ve followed the directions on the battery compartment, which should have specified the correct orientation of the batteries. The Swiffer Wet Jet won’t be damaged if you poorly put the batteries, but it won’t operate.
  4. Reassemble the mop once you’ve replaced the Swiffer Wet Jet batteries. To accomplish this task, a liquid cleanser and the battery cover may be reinstalled. To release the cleaner, press the button on the pole to release the Swiffer for testing. To check whether you put the batteries properly, you may open the battery compartment again and look for any liquid that may have leaked out. ‎




Also See: How to remove castle nut without wrench

Leave a Comment

Your email address will not be published. Required fields are marked *

error: Content is protected !!